RM Cycles workshop

Workshop Services

We a have fully eqipped 10 bike stand workshop in our Tenterden shop. With trained and experienced mechanics at the helm to deal with your bike servicing needs.

We do not offer a specific time slot to carry out the service on your bike. All we say is, that to give everyone fair treatment, we give our best attempt to finish within 5 working days - depending on the availability of spares. We keep a high level of service parts but during busy periods stock can run lower than expected.

You will get a phone call from the mechanic to confirm prices with you before any new parts are fitted. We will not continue with any work until we have spoken to you first, so accurate contact details are essential. Any worn/broken parts will be disposed of unless otherwise requested. Your bike must be collected within a week of it being serviced or repaired. We reserve the right to charge for storage if bikes are not collected within a reasonable time, unless otherwise agreed.

The Gold service starts from £220respectively. If your bike is a Full Suspension mountain bike and requires a full strip including removal of the linkage, the service will be £300 to cover the extra time for the removal and rebuild - if bearings are required they are at a additional cost.

Additional Workings


Apart from our services listed above. We can do almost anything to a bike that doesn't involve welding or carbon repair.
The services listed below are charged at £70 an hour - and we work to the nearest 15-minutes/£17.50.

We also offer the following individual workings:

Brakes:

Hydraulic brake bleed/service - £35 per brake
Hydraulic pad replacement, including piston clean - £15
Cable brake service - £25 per brake

Drivetrain:

Gear tune - £30
Gear tune plus cable replace - £45
Wax chain, including degrease/prep - £25
Bottom bracket replace - £35
Swap cassette - £10
Fit/replace chain - £10
Firmware update - £25
Di2/AXS/EPS Diagnostics - x Hourly labour Rate

Frameset/components:

Headset replace/service - £35 (does not include internally routed cabling)
Handlebar swap - external routing £35 - Internal Routing £120
Dropper cable replacement - £30
Wrap Handlebar tape - £20
Mudguard fitting - £40
Fork/Shock/Dropper service (sent to appropriate service centre) - from £150

Wheels and Tyres:

Inner tube replace - £10
Tubeless setup - tape, fit tyre and sealant - £35 - Does not include cost of tape, valve or sealant.
Tubeless sealant top up - £5
Wheel build - £75 per wheel
Wheel re-build - £100 per wheel including spoke replacement and true (Additional cost may occur depending on parts required)
£30 (tube type)
£45 tubeless
Wheel true - £20
Tubular tyre fitting tape - £30 per tyre
Tubular tyre fitting glue - £60 per tyre

Hubs: